1. Ensure the mirror is fully charged by inserting Micro-USB cable into the port at the back of the mirror and attach to a USB friendly power source.
2. Slide the switch to the ‘ON’ position. The indicator light will turn red when charging.
3. Press the button on the face of the mirror, to activate lighting. Tap and hold the button to adjust dimmable light settings.
4. For a free-standing mirror, pull the stand out at the back and place horizontally or vertically on a flat surface.
5. For magnification of certain area, attach the magnetic mirror attachment to the mirror face.
6. It may take up to 3 hours for the mirror to be fully charged. Keep stored in the protective sleeve for safe keeping.
To reduce the risk of burns, electrocution, fire, or injury to persons: read all instructions before using the appliance. To protect against electrical hazards, do not use while bathing or in the shower.close supervision is necessary when any appliance is used by or near children or persons made weak or disabled by illness or injury. Do not operate this appliance if the appliance malfunctions or has been dropped or damaged in any manner. Return appliance to nearest service facility for examination, electrical or mechanical adjustment, or repair. No repairs should be attempted by the consumer. Use appliance only for intended use as described in this instruction book. The use of attachments not recommended by stylpro™ may cause hazards. Do not use outdoors or operate where aerosol (spray) products are being used, or where oxygen is being administered. Be sure glow & go mirror is not in a position where it can reflect sunlight; reflected sunlight can cause fire. Do not use on a soft surface such as a bed, where openings may be blocked. Turn switch to ‘off’ position before storage. Do not use appliance in the bathroom. Do not place or store appliance where it can fall or be pulled into a tub or sink. Do not place in or drop into water or other liquids. If the appliance falls into water, do not reach into the water.